Check that a set of wheels will actually fit your car before you order it: bolt pattern (PCD), centre bore, offset and the tyre size change. Everything updates as you type, and nothing is submitted anywhere.
Typical factory fitment: 5x112 · 57.1mm bore · ET35–50. Golf, Passat and Polo before 2005 use 5x100 with the same bore.
All three numbers are stamped on the back of the wheel or on the inside of the rim, usually next to the width. Every result updates as you type.
Wheel bolt pattern (PCD)
Enter the pattern stamped on the back of the wheel, for example 5x112. A 5x112 wheel is the standard fitment for this car.
Centre bore
Measure the centre bore of the wheel. This car normally runs a 57.1mm bore.
Offset (ET)
Typical factory offset for this car is ET35–50. Check the ET stamped on the wheel.
Where to find the numbers on your wheels
PCD — stamped or cast on the back face of the wheel, usually next to the width, e.g. 5x112.
Centre bore — the hole in the middle of the wheel. Measure it if it is not stamped; it is normally a whole number of millimetres.
Offset (ET) — stamped as ET followed by a number, e.g. ET45, on the mounting face or behind a spoke.
Tyre size — printed on the sidewall as width / profile R diameter, e.g. 225/45R17.
Your car's figures — the wheel you already have gives you the answer. Read the ET and width off a wheel you know fits and use it as the baseline.
Fitment questions we get asked
Still not sure it will fit your car?
Tell us your registration or VIN and we will confirm the exact fitment against our 12,000+ part catalogue.
Guidance only. Factory PCD, bore and offset figures are typical values for each make and can vary by model and build year. Always confirm the fitment for your exact car before ordering, and have the alignment checked after fitting new wheels.